here we have our M 195 Visor the monogram goes right here we use one sheet of cap backing begin by folding the cap backing in half and align the center fold with the center of the cap frame slide the visor unto your prepare cap frame over the cap backing pull bottom of the visor tight to remove wrinkles pull strap over the bill of the visor in secure latch secure the bottom l divisor with the gathering clip measure the bill to find Center and mark it with tape on the Bison slide cap frame on to machine being sure to keep the bill from hitting the needle areas rotate your monogram 180 degrees check the divisors Center by using your tape mark and trace the monogram area during tracing be sure that the mudroom area does not interfere with the metal strap remove tape and you can begin sewing all of the items used in this video can be purchased at wholesale boutique on our extra heavyweight tearaway cap back in comes in pre-cut pieces of 250 per pack this backing is especially designed for embroidering unfinished unstructured cats and visors this larger custom cut size gives you more stability and manages your embroidery area it also tears away easily and cleanly we only use magnet glide bobbins here at WB their patented magnetic core creates a consistent delivery throughout the entire bobbin no more interruptions for tension adjustments that your bobbin gets smaller carefully remove the cap frame from the machine by rotating it past the needle area remove the gathering clip and then unlatch the strap to release the visor tear the backing off and you will have a finished product click the links in the description below to view the items used in this video