hello my name is David getting from by-the-book construction in Camarillo California and today I'm here to show you how to replace a ceiling light fixture and the tools we'll need today are going to be a pair of pliers a screwdriver and a set of wire nuts and we've turned the breaker off and we're going to drop this nut down holds this trim piece up so we can see the wiring underneath now the left cord has two wires once black one goes to the white it doesn't matter which one you take off first because powers off so we want to disassemble the black and the white wire there is two lamp cord wires now the lamp lamp itself is screwed up into the light holder bracket disconnect the ground which we've done now that our light fixture is down I've taken the new light fixture out of the box and have settled it due to the instructions and we want to thread the cord through the cane periodically not every length but every once in a while and then we want to put it through our fixture - at the end all three wires go through and when we hook these wires up it says in the directions that the white lettering on on the lamp cord wire is going to click to the white neutral wire the other one is going to go to the black and of course the copper wire goes to the ground okay now I have the light assembled I'm going to stick the wires up through the mounting bracket in the ceiling and so when we are connecting to that's going to connect the whole fixture to the ceiling bucket when you screw that in screw down a little ways we explained it before that the white wire is going to be connected to the lamp cord wire that has white writing on it and we're going to connect that to the white wires with our wire nut and then the remaining wire the wire without the bright white writing on it is going to attach to the black wire coming out of the ceiling and our bare copper wire is going to get wrapped around the little green screw in the mounting bracket and will that knot down with a GU driver now that that's all assembled we can push those wires up into the box so you don't hang down any more slide the trim piece up and on the tubes going to fit up tight and then here is the retaining ring go around it threads onto the hanger bracket now this is the final assembly for the light fixture we want to put the glass globe over the top of the socket and then there's a white nut that screws down that's going to hold the glass onto the fixture itself my name is David getting from by-the-book construction in Camarillo California and I've just shown you how to take change a ceiling light fixture thank you very much