everyone itsu from the heat transfer source today I'm going to show you how to cut the Holograms using the silhouette portrait you can also use these same settings to cut our metallic material the first thing you're going to do I've uploaded a pawprint here you're gonna go to your cutter settings you're going to select that you're gonna scroll down to the cutting options you want to select cut because we're going to cut this out we're gonna scroll down it's gonna give you the choice of different materials that you can cut for the Holograms and the metallics I select the heat transfer material flocked it gives it a deeper cut if you scroll down a little farther it actually shows you what you want to set your blade add we're gonna set the blade at 3 these cutting cutter settings work perfect for this one you're going to unlock your cutter from the machine you can pull it out this actually shows you the red line here shows you where your ratchet is set at and here it's already set at 3 if you needed to change it you would just use the little hole that's here actually turns it very simple and clicks it into position for the settings so we're gonna go back to 3 we're going to insert it get into the machine make sure that you lock it into place there it's locked in we're gonna go back over here I'm going to show you you want to apply the material we're gonna do shiny side down onto your mat you're gonna line it up on there you don't really need to press it down hard you're gonna take it back over to the machine you're going to line it up with there's little lines on the machine already there for you there's three buttons here the top button is to load your material using a mat the second button is no matte and the third button is to remove the material from the machine since we're using a mat we're gonna press the first button and it's going to take your material into the machine so your machine is all set up and ready you're gonna come over if you look to the bottom here it says send to your silhouette you're going to click that button it's going to send it over and start cutting for you as you can see it's telling you that it's cutting right now once it's done shows you it's finished you can then hit the third button down which is to remove the material from the machine it sends it right out to you you can actually look on here if you look really close you can see that it's cut through there I'm gonna take the material remove it from the mat which it comes off pretty easily to save the material that you didn't use kind of look you can see where the image cut onto that I cut that off so I can use it for the next project and then you're going to weed this out it's a super easy to weed once you get the corner up and you're going to pull the material apart how easy it is to weed perfect you now have your image all cut out and ready to be pressed thank you [Applause]