rough edge around it and so instead of once I've got it mounted I'll show you some other options for further enhancement or different techniques for actually mounting or matting papyrus or matting any any picture but in this case they want the deckled edge showing so it's going on it's not going a particular big frame but it is just going on to this black backing which I've already pre-cut to size so at this at this point in time what I want to do I'm going to flip it over onto the to the white side actually might be a little bit white white fright on the time you use for and we may use more if we decide to put some down in the center them and I don't really think that we'll need it need it in that in that point now what I'd done when I'd cut through that that board I'd roughly cut it 20 mil in from the in from the edge and so I can see here on on the table pretty much where that that slot is going to be relative to the tape that I'm putting there and the slot is actually cut away so it's it's a reverse bevel so the the slide is away from the artwork so what we're going to do is we want to put a little bit little hinge tape on the end that something else that's popular is adding a fill it Phillips make a lot of difference of these sorts of things like I've just got a very decorative one here but it should sharp okay on on the camera because we got this sort of bright gold now again that may go where they use a fill it on the inside and around it or likewise a fill it outside and still have that edge now you can have any various combination of using background color that you mount the papyrus two combinations of mounts mats Phillips to enhance it to your client or your needs and that's normally where it's best to hold those things up and say here's a few and just see how the the finishes see if there's any dust so now at this stage I'd turn it over I've actually got our papyrus in here and I'll give it a bit of a clean and say same sort of thing spray it on the surface often they'll tell you don't and this is it's like you see me spraying the glass here be careful some frames are susceptible to glass cleaner so often you'll read or even then glass manufacturers will tell you spray the cloth and use the damp cloth and then have a wet cloth and a driver