all right today we're going to make an air soft pistol silencer what you'll need is just an airsoft pistol some toilet paper any cloth will work and an old film case empty film case alright you take your film case and you take a knife and cut a half inch cut there and across like that on the bottom you're going to cut a hole doesn't have to be precise just wear it centered not this one centered but there's a center so the Beave you can leave it as an exit point all right you're going to take off the cap take some toilet paper you want to cut it to size that's the same width as the film case and you're going to roll it around an object that's bigger than six and eleven six millimeters I'm using my finger you roll it into a circle like this if it's too big just cut it off and you want to stick it into the film canister and just make sure there's space right there for your fan on its face put the cap on snap it securely then with that crisscross cut and you want to stick it on the barrel of the gun sometimes it goes too far just fit it properly and take your mag I have like one round in here and there you go pistol silencer