if you've ever struggled to replace an electric shower to the pipe and cable positions and the t-80 said faster it is the shower for you it has eight water entry points top back bottom and side entry on the left and the same again on the right and six electric entry points top back and bottom on the left and the same again on the right this makes it a hassle-free fast fit every time it's ideal for new installations and perfect for replacing most existing showers providing the existing electric supply complies with the relevant safety regulations and the water supply is adequate you can fit a t-80 said fast fit with the same kilowatt rating as the old shower in no time at all let's see just how quick and easy it is to replace a typical Meyer V installation with the t-80s and fast fit first make sure that the electric and water supplies are isolated now unscrew and remove the cover test to check that the electric supply is isolated before detaching the service tunnel here the water and the electric supplies enter from the rear on the Left disconnect the supply cable then disconnect the water supply remove the war fixing screws and remove the shower from the wall now for the T 80s ed fast fit take off the bottom trim plate and fit the top pipe entry trims water connection is required on the left so the Swivl water inlet does not need to be adjusted electric connection is on the left the swing fit terminal is supplied assembled in this position so no adjustment is required position the t-80 said fast fit over the existing screw holes then measure and cut the length of pipe needed to extend down to the shower inland connect the pipe to the coupler fit a compression elbow onto the swivel Inlet and connect onto the water pipe check the backplate is level and mark the new wall fixing points next remove the unit and drill and plug the new hole place the unit back on the wall and connect it to the water supply then screw the back plate to the wall fully tighten the water connection and turn on the water to check for leaks connect the supply cable to the terminal blocks making sure that the connections are fully tightened now fit the bottom trim plate click the power indicator light into the front cover make sure that the controls are correctly aligned fit the cover and secure it with the three fixing screws finally connect the hose to the unit turn on the electric supply and commission the shower on a cold setting now there's just the shower kit to replace if you haven't already done so remove the old kit from the war in some cases you can use the existing fixing holes for the new shower kit start by fitting the top fixing plate to the preferred height using the existing hole if possible then slide the bracket onto it now fit the shower head holder the soap dish and the hose retainer onto the rail fit the bottom bracket and fixing plate onto the rail under the line with the holes in the rail and secure with the long screw next guide the rail into the top bracket the rail can be adjusted in this case to line up with the original fixing hole there may be times when a new fixing point is needed now screw the bracket to the wall at the top and the bottom trims feed the shower hose through the hose retainer fit the showerhead to the hose and finally place it in the showerhead holder all done it's as easy as that the t-80 said fast fit is an ideal replacement for the my RV in this case with only a minor alteration to the plumbing and no additional work on the electrics is required a quick easy and hassle-free installation all thanks to multiple entry points and water and electric connections on the left or the right the t-80 said faster it is the ultimate replacement shower whatever you're looking for in an electric shower the tryin ta TSN models can satisfy pretty much all requirements if you're looking for a discreet electric shower then why not take a look at our t-80s edge slim line video or if you're after a family safe electric shower with thermostatic temperature control then watch our ta TZ thermostatic video thanks for watching