alright now we've got our camel clad all over the side of the boat the last thing you want to do after you get it all trimmed out let's take a heat gun or a hair dryer and actually heat the vinyl up and go over it with your squeegee again and burnish it down real good using good hard firm pressure what this does is uh just sets that vinyl on to that metal by eating it up now we've got the side of the boat all done we're going to show you to do the transom we pulled the motor off we clean the back you know washed it with the scotch-brite pad wiped it down again and put preps all on it just like we did the sides get the boat the motor out of the way we've got our piece pre-cut ready to go we're going to have the seam over here on this right side and we'll stick this piece up level it out here put a little more the backing down so we got some adhesive down here where the rest of the transom is alright the other thing we've got we've got a tie down hook right here so we're going to go go ahead and make a cut for that hook they're set on in there then we'll take our squeegee and we'll work that final down all the way around that hook a little bit of a wrinkle there so we're going to back it up a little bit work that on out of there you're right we're going to run across a couple screw holes here just work around those a little bit we want to take this loose from the top tuck that back underneath there make sure we get good and tight get our other tie down hook right here put that in place we're going to make our scene probably right around this other hook will come in on the other side right around where this hooks that so it was like on the sides you just kind of keep a little tension on it down here at the bottom just keep working it down if you get any wrinkles you can just put your hand up underneath it like so push it loose and then just continue on now we reach the bottom of the boat here we can turn this out and then we'll just trim our bottom piece off here we'll be ready to go all right now we've got the transom all done go over it with your heat gun we're going to finish the other side and we'll we'll have this jon boat all wrapped up got a camel clad it looks great sure looks like a super duck hunting boat here we finished our camel clad boat project we've done the whole boat both sides the transom it looks awesome this is definitely going to be a nice looking waterfowl hunting rig it's not a hard project at all to do so appreciate your time and hope you enjoy the camel clap products