how to replace suspender clips from the holdup suspender company replacing suspender clips is easy and can be done in less than two minutes all you need is a pair of needle nose pliers and good lighting each clip is made of before basic parts the ring which holds the webbing the lower jaw with two ears that bend the upper jaw with a locking pin and the cam with the side nipples which opens and closes the clip step 1 using your needlenose pliers remove the defective clip from the webbing by slightly bending one ear out just enough to slide the cam off step 2 remove both the upper and lower jaw leaving the ring on the webbing step 3 pick up the new clip and just like before slightly bend the ear to allow for the parts to be separated step 4 start with the lower jaw and attach it to the ring of the suspenders step 5 connect the upper jaw to the lower jaw you should feel a spring-like tension step 6 place the cam on next by slipping one of the nipples into the unbent ear hole of the lower jaw while holding the clip together then the ear back into place so that the other nipple ends up in the ear hole check to see if your clip opens and closes properly and if so then you have successfully replaced your suspender clip for more suspenders or clips visit us online at