okay today I'm going to show you how to make a hand spinner so I mean three ball bearings two big zip ties and two small zip ties so the first thing you're going to want to do is to take the tip eggs your ties and put one end which I pretty much just make this okay once you've got this you take your three bearings and you find out which one is longest and this one spins the longest stopping it down in the middle and then we are going to want to do is tighten these zip ties okay once you've got like this you don't want to cut these ends off yet cuz you're still gonna need this once you've done this you're going to need your smaller zip ties so what the small as it does you're gonna just want to just do one click so it's barely Luke put it on the end of this and just put it right there and then from there you tighten it so it's right in between those two bearings you don't want to make it too tight you and then you do the same thing to the second one you're done it should look like this so what you want to do next is just tighten all the zip ties as much as you can after you tighten them you should be done if you want to you can do it I'm going to do next which is add these two zip ties on the bearings to make sure the bearings not fall out you know what that it will look like this now you can just cut off the excess zip ties aren't you done with that you've got your hands fit if you wire has better to spin faster and longer check out my other video on how to clean a ball bearing