brought to you by 1auto.com your source for quality replacement parts and the best service on the internet hi i'm don from 1a auto i hope this how-to video helps you out and the next time you need a part for your vehicle think of 1auto.com thanks in this video we're going to show you how to service the parking lights on this 2000 chevy cavalier pretty much the same as a 2000 to 2002 we're going to do the driver or the passenger side which is the right hand side procedure is the same for the left-hand side you'll need a flat blade screwdriver screwdriver that should be the only thing you need but a pair of pliers might help as well open up your hood and there are six clips to remove that hold the panel on you can see i'm pointing them out right here use a screwdriver or a pair of pliers and pull up the center of the clip and then you should be able to grab onto it and just pretty much kind of shake it back and forth and pull it up and out and i'll just fast forward here as we remove uh the rest of those clips and you can see some of them take a little bit you kind of pry up and get that center pulled up and then work them out and now that panel goes up in the middle and lifts out to release the parking light there is a little clip that you access right down through there and pry out with the screwdriver and you see we're prying out and we're actually pulling on the light at the same time it takes a minute just to kind of get everything right you gotta release the clip and pull um and then usually when it comes out it comes right out and then you can see the clip right there and you just twist the socket there's a little tab to press on twist and it comes out if you're looking to change the bulb it just pulls straight out and put a new one back in okay new light for money auto is on bottom it's all the same just newer clearer and not broken if yours is broken there are three tabs on the light that line up with three holes in the headlight and fender reinsert the bulb and twist it to lock then put the light in look back in the back make sure that those three uh pins are lined up to the holes and once you get them lined up you give it a good firm push and it snaps into place and put that trim panel back in place kind of work it under one side bow it up in the middle work it in under the other side and then put your six clips back in place and you should be all set and the clips you want to make sure that the center is pulled out you put the main portion of the clip back in and then you push the center down to lock it in place we hope this helps you out brought to you by www.oneauto.com your source for quality replacement parts and the best service on the internet please feel free to call us toll free 888-844-3393