hi i'm making a zigzag memory wire bracelet today um we need a single loop memory wire overlapped by a centimeter roughly um so you're going to take your flat pliers and just reduce it in size just it's overlapping either side by about a centimeter like so so that when we turn the loops they will come up together so you can use it as a cuff we have 22 gauge wire we need to use about probably 24 inches 60 centimeters we need a small selection of seed beads in two different colors or you can have them in just one and you need nine six mole beads i lost a claw so what i'm going to do to start off with is get the end of the memory wire with the round nose pliers still again to the middle part of the plier but right at the end of the memory wire and you want to try and roll it towards you to make a loop on the outside like so and then what we're going to do is take a length of 22 gauge wire one piece is long enough to go all the way around and then what we're gonna do is just take about a centimeter or so of the wire it's going to try and tuck this around the memory wire to hold it in place so you want to wind it round three or four times right really close to that loop that you've just created and then use your pliers just to pull it round squeeze into place so don't move we're then going to take i'm going to make this one quite fancy i'm going to use two different colored seed beads and i'm going to have i've got three seed beads on each side of the little zig zag you're making so i'm going to thread a green bead and a blue and a green into the wire and thread one of the larger beads on and green blue okay the seed beads by the way are a size eight seed i'm gonna thread them down and we're gonna bend the wire so it looks like a little u-shape and then what we do is wrap the wire around another layer twice it's tight like so because it's why you can still only pull out the shape so until you're happy with what you've got and then you thread the beads on again it looks exactly green thread them down again and bend the shape again on the curve as you go kind of hold your beads on top of the wire and then it'll stay in position where you want it if it's coming out a little bit too far you can always take the pliers and squeeze it up together a little bit more bring the wire back at the top you keep going until you work your way all around the memory wire it usually takes about the nine beads it could be possible if you make them closer together you may need to put more on but nine of the main beads is usually about right oh i suppose it's quite a good idea it could be used for soviet rings it could be used to make earrings if you like large um show stoppers once you get close to the end on the last loop we're gonna wrap the end back around twice three times make sure you've got enough space to turn your loop so you might want to pull it in a little bit and then you're going to turn yourself the loop on the other side you've then got something to anchor the wire against the next two little squeeze if you can't get it close enough and then you just finish wrapping the way around so you end up with a shape looking like that and then we've got one loop on one side to use for the fasteners what we have to do is take your lobster claw and reopen your hook back up and put your lobster claw back into it and then lobster glow will hook into that loop because it's fastener and you have your little underwear bracelet you