Canyon Grail headset play I got new Grail CF SL 8 and my headache started when I realized I cannot make headset play stop. After tightening all the screws to exact values I can still produce play on my steering wheel. Description, I stand over my bike and hold both brakes fully. Then I start to push bike forward and backwards and I can see my forktube covered with cap going forward and backward (gap becomes smaller and bigger depending on the movement). All the screws inside are: 1. 2x rear to lock the plastic plate to the fork (fixate steering wheel) 2. 1x top cover 3. 1x transitional plate ![enter image description here]( < Tnx for help in advance.

Just tightening the screws will not resolve the issue. There is a precise but quite simple procedure to follow. You can find a number of very good explanatory videos on the internet. GCN has a recent one on unboxing that specific bike that might be useful.

The usual procedure takes three steps:

1. Undo the pinch bolt(s) on the stem, normally two, left and right on the stem by one turn

2. Tighten the top bolt until play disappears while the bar still moves freely from side to side. This requires some sensitivity.

3. Tighten the pinch-bolts with the recommended torque!!




Then recheck the free movement of the bar and re-adjust if required.