okay I'm going to show you an easy way to bend tubing without kinking you can see here that I started bending on this and it was kinking so I had to stop immediately I came up with a different way well I found a different way I didn't come up with it first we're going to take this tape and tape off one end of it then on the other end I'm going to tape the funnel just like that then in this case I'll have sand we're just going to fill this thing up with sand and it don't take much does that to goose is it's already full right there just kind of tap it down in there good go ahead Gators full much as you can so if there's no gaps in there and then you will just take off this in I'm just going to use this pulley for demonstration to bend it around well now that you have your sand in there you can go ahead and and bend it and not get a kink in it really nice pin just like that there's a slight minor little bend there but I could have avoided that if I would have went slower see there it makes nice spins and you don't get anything