today we are working on a 2007 honda accord and i'm going to show you what's going on with these turn hazard lights if you listen carefully you'll hear a irregular buzz and the turn signals won't work you'll also notice that if you go to press the hazard you don't have any hazards or you'll have just a brief flash before nothing happens so let's see if you can hear that buzzing and what that pretty much means is that your turn signal relay has failed and the turn signal relay also powers the hazards and it just has six tabs on it you can see those six tabs there and they go out to the respective turn signals uh that they are commanded to use so i'm going to show you how to replace that it's pretty simple uh you just have to get into a tight space so if you're a big person good luck so to begin locating the turn signal relay what we will do is come to the driver's side foot well and then turn left and come down and up and the turn signal relay is in this electrical cluster right here and the easiest way to find it is to turn the turn signal so that it makes a buzzing sound like this and then feel around and listen around and put your hand on whichever relay is making that noise so now i'll just reach in there and touch the relay that's making the noise i have it in my hand so i can pull it out and show you so i can't really show you but i'll take as many pictures as i can but when you're pulling the relay out it's the one that's just above that yellow connector what you'll do is you'll feel around there's two tabs on either side and what i do is i push my finger underneath one of the tabs and then and then try to pull it out and wiggle it out so see so i just got it like this so what i'm doing is there's two tabs there's one tab that holds this piece side down and this piece side down and what i'm doing is i'm putting my finger underneath and lifting this tab and then grabbing the top and the bottom and wiggling it this way pushing it forward and then pulling it out and that's how i get around that other clip if you're having difficulty you can just use a small screwdriver to kind of pry that clip out and then pull it out of the way but you're only going to be able to get one hand back in here and i was able to confirm that the position for this relay is just above that yellow connector so you can see right now the relay is removed and the relay only goes on one way the relay is notched so you'll see on that connector there's a little notch piece sticking out and that cords corresponds with the relay itself so if you're looking at the relay it'll go back on not side down and the notch side is facing the rear of the car it goes in just like that today we're working