in this video I'm going to be showing you how to attach game boards to the wall now for this we need a few different drill bits first of all we use a 5 mil drill bit to drill through the skateboards then use a countersink bit to take the head of the screw ones are the surface of the wood so you can fill it later and then I go through the wall with a 5.5 mil makes me be nice to accept the red blocks and then I like to use a three inch 10 which group remember if you've got any plug sockets in the wall the wires usually run straight up and down from them so bay this in my benefit and skating boards because if you look underneath there's the wires we do not want to put a screw through them i've pre-marked a few positions I'm escaping boards where I'm going to put the screws now I avoided the sockets but I've also got a bit bit of a belly in the wall so important one here so pull the gap into the wall notice that the screws postgame was in a bit too much because of missing plaster behind like this one else it's simple enough you just need to pack behind it with a bit of timber little of course or a bit of plaster board whatever you got to hand really what the back you have where the screw is and just tighten it up again three fixes was enough to secure this back to the world a little bit of caulk along the top there'll be a good job thanks for watching if you enjoyed the video don't forget to subscribe to the channel see you next time you