I received a question from Thomas in Ireland regarding the mTEC 2 litre pressure sprayer you 2275 question was how did you assemble it pumps water out it could be for watering your plants it could have plant food in tomato feed or whatever basically Thomas I filled the container up I've only put a small amount of water in for the purpose of this experiment so I've got a small amount to probably half a liter in here when you take the top off the pressure sprayer inside you'll find a piece of plastic tube don't throw this away it's important because without this being inserted in the head it won't work inside the head there is a little green connector point here you need to insert the plastic tube into that just give it a push in that's all it needs and so when you put this in the neck of the bottle you've got the main siphon tube and you've got this little capillary tube the little thin one on the outside you put your fluids in and any plant feed or whatever you're putting on I even use one of these at home for alloy wheel cleaner on the cars so spin that round gently nip it up now all you do is pump the hair look something need too much that would be ideal that's pressurized the air against the liquid now I've just got a little bowl here so you can see it work the button to switch it on this here so you can see the water coming out you can adjust using this brass milled piece of brass at the end here whether you want it really fine or whether you want it so here I've got quite a fine spray there I've got it coming out more of a rose fashion so you can adjust that to suit and then if you need to lock it on if you've got a lot of spraying to do you can hold the catch down and move this green there's a little green plastic molding with arrows on if you move that down and forward you actually can lock it on so here you can see I'm just spraying out there I can very to a fine jet here so hope that helps any other questions please go to amptek diy.com be pleased to answer them