hi today we going to make Canterbury bells materials required are crepe paper in blue, you can take any shade of blue, white, or pink, and green, for the leaves, some pips which have white heads, a thin wire for tying, green floral tape and a thick wire all measurements are in centimeter this is the stencil of the petal inner petal this is 5.5 centimeter wide on top 5 centimeter long and 4 centimeter wide at the bottom these fringes are one centimeter high this is of the second petal this is 9 centimeter on top lengthwise 4 centimeter long and 6.5 centimeter width and the bottom and again the fringes are one centimeter high cut 1 - 1 piece per flower of both of them and make about ten to 20 or 17 flowers per stem this is a stencil of a leaf a small leaf so 3.5 centimeter by 1 centimeter wide and the stem is 0.5 centimeter and 0.5 centimeter wide cut two leaves per flower and this is of a bigger leaf this is 5 centimeter by one centimeter and again the stem is one centimeter and 0.5 centimeter. cut the leaf the same number as you cut flowers take the first stencil of the petal the inner petal and first stretch the fringes just at the base of the fringes just pull them in one direction like this and then at the joint also again stretch do it a little carefully because otherwise you can tear these edges and then from the lower half stretch it in the opposite direction outwards like this this is the shape you get now apply glue on the edge and stick this over and let it dry now take a pair of scissors and curl the fringes outwards you can do this before sticking also if you like just curl them outwards now take the second petal and stretch again in the same way as we did earlier first stretch to fringes the base of the fringes and the joint area also then apply glue on the side and stick it over now curl the fringes again as we did earlier now insert the first petal in the second one till the base and insert this pip in it also the height of the PIP should be just below the cut of the inner petal and then just hold the base together like this just fold it up like this and tie it with a thin wire about 20 centimeter long thin wire and just tie the base - pull it hard twist it so you have a stem now put a little finger inside the first petal, the outer petal and open it out ope out all the creases like this make it a little bulge at the base so it opens up like this you may have to curl down the petals again and in the same way curl out the inner petal now take the 2 smaller leaves and curl them using the scissors now take a piece off the floral tape and stretch it first start winding it from the base, base of the flower come down about an inch on the stem then take one small leaf and hold it on the stem and wrap the tape over then take the second leaf put that also here on the stem and wrap it over and wrap the tape till the end of the wire now open out the leaves like this just pull them down so that they curve out like this now hold this flower on top of a thick wire that you've taken and cut a piece of a long strip of floral tape and stretch it and start winding it on the thick wire and then take a bigger leaf and put it there just like we did for the smaller leaf now put another flower just below the first one we wind the tape a bit and then again put the big leaf so the idea is put a flower and put a leaf at the base so keep putting flowers all around the stem like this after you've covered the whole thing just open up the flowers in all the directions and the leaves just opening the flowers out first and this and then open out the leaves just go from the leaves and this is how it'll look this is with more flowers I have made another one with slightly less flowers which will look like this