today I'm making a jack for this build you'll need lumber a drill wood screws that's it Jack C used to hold up sets I need to make a set so I'm making jack so take scrap lumber preferably two by fours and arrange them like so make a giant L bracket protip this is easier if you drill pilot holes figure out where these support risers are gonna lie and mark them in with a pencil should be at a 45 degree angle cut along that line on both sides now attach that piece okay so now I gotta attach that piece is just sticking out like that and basically that's the hold a sandbag or some kind of a weight in order to counter weight the weight of the set keeping it from falling over onto your actors they're not so crazy about that normally and not should be cut and the long end but there's actually a hole in this particular plane which will work out fine for my purposes especially since I'm using it to hold up foam core flats which don't weigh anything kill everything in place and there you go one Jack now repeat that for every four feet of set hey thanks watching like that video then you can subscribe my support the channel then you can check out my patreon page that's the little orange cooler up in the corner there and check out some of my other tutorials right here thanks for watching check out