today we have this beautiful globe lap bias as in trade and we're going to walk you through the steps of cleaning this lap and making sure that it's in pristine condition teams first of all make sure that you have a damp towel and then you also want to make sure that your hands are dry and clean before you touch the salt line you see that the salt lamp is centered in the middle of the table and ready for use first of all identify the finally dimmer cord gently turn it to its off position and put it to the side next what you want to do is take the plug and unplug it from the electrical outlet make sure that you are safe if while you're doing this as you're dealing with electrical unit next we want to gently tape over the lamp to the side and hold it on one hand where as you pull the lamp they do report out with your with your other hand this is a clip-on unit so make sure that when you press on the denpa press on the butterfly tents you're not pushing it too hard and you want to gently pull it out from its socket next what you want to do is put the sock the butterfly clamp to the side and bring the lamp back to its original position once you have the bulb taken out of the lamp you want to make sure that it's clear of your work area as you do not want the bulb to shatter are once you typically ring from anywhere between five pounds to fifteen down for example the same block curls around 40 pounds so you don't want it you want to make sure your bulb is clear next what you want to do is take the wet towel that we have and gently wipe down your line from top to the bottom make sure you go around a couple of times spin the right lap around and put it aside clean the base usually we might have some salt crystals looking at the base of the lamp so make sure you clean that one base pretty well turn the lamp around frequently and you know gently walk work around your lamp make sure you don't see any crystal residuals or white powder at the base make sure you go top to bottom a couple of times and you can see that now you have a pretty pristine amazing looking lab that you know has its own glow down next what you want to do is take like a paper towel or you can take a newspaper even make sure it's dry and slowly block the lab this will remove any excess water that you have from the cleaning process that you just went through as seeds again work your way around top to bottom work the lamp around spin it around but make sure you took clean up the base and there you go you can see you touch it a couple times and you'll feel that's not wet anymore next what you want to do is take the record with the bulb press down on the butterfly clamps again as we did initially turn it to the side on your hand and slowly insert the bulb back into the lab don't push too hard because you don't want to watch the crack the bulb inside so you'll you know just push it inside and you'll seize if it's not protruding from underneath and when you're putting it in you're not feeling resisting the pressure back in and you know you're okay next and also make sure that the cable goes through the groove at the bottom and kind of pull it to the side once you feel like the lamp sitting on a stable position take the power cord plug it back into the electrical outlet take the damn liqueur and slowly turn it back on and you'll see the beautiful looking Himalayan salt line come back to life I hope you found this video helpful please so please share it and make sure you check out our beautiful collection of in the land salt lamps at WWF entry calm thanks again