basically I get to the headlight housing I'm doing that screw will allow me to take the whole headlight housing out that's where you need to get get to do this socket and that's the bulb the original halogen you undo the sleeve and keep pull out the ball to come out for one headlight this is the nine zero zero seven model and for one headlight you have the fan adapter you have the LED high and low beam that screws onto the fan you also have the driver which we're going to mount to the side the vehicle and here's your nine zero zero seven base the LED we're going to get it into the headlight housing now it's important to know which way your headlight is because we're going to want the low beam to face up and then shine down and the high beam to put a face down shine up and these notches allow you to put it in the right way without getting it wrong line up the notches should do it and you want to make sure that when you put this in there some of these will not lasting housing so just do your best to go up have the LED pointing facing up and down that'll be your high and low beam low beam faces up high being faces down I'm going to position the headlight housing back in there just to make sure that the LED is facing upwards and downwards as much as possible I can see I can probably rotate it a little bit my sleeve is going to tighten it down I'm going to lock it in with this sleeve it is a little tricky because you have this wire right here coming right out of the side of the base follow that in you're just going to kind of jam that wire up for me I just gotta lock it under these screws let's locked in there and then the wire comes up from the sleeve and I want to check and make sure that I still see that my OD is facing upward and straight down and straight up and down how we're going to attach the fan and I throw it on to the back of the led yeah you got to clear this get that up there let's throw out this all the way in and watch out for the wire you don't want to crimp your wire so once you thread it in tight good to go while I thread that in there the positioning of my LED moved so I'm going to reposition it again this is just the process you'll have to do quite often the positioning that LED head straight up and down I'm just going to tighten alright now we're going to hook up these mating connectors to our driver here you can see there's the two mating connectors one is for the fan the others for the light this only goes in one way you can see the the key knot and make these connectors together and finally we're going to make the socket to the base all I do here is push the connector it's all wired well I'm going to test that connection now by turning on the headlight all right now that you have all of this stuff that you wouldn't normally have with just the bulb you've got to make sure you find its way back to your engine compartment and leave room install the headlight you