Get rid of those instructions why because you don't need them you've got IKEAHUNK Would you rather be Wayne Newton or the IKEAHUNK? well its an no-brainer Who? IKEAHUNK OK as you can see tom has both sides of a nightstand laid out and you're going to need eight of the 20 long neck metal screws therefore for each side notice their two sizes of holes next to eachother and for this step we will be screwing into the smaller holes next you're going to take the four rectangular plastic plugs and insert them at the bottom of the nightstand or the edges has two screws in it already just going to finish screwing your eight screws in now here you are going to use the two narrow pieces of wood and the two wider pieces insert one wooden dowel on each end of the four wood pieces you have three painted pieces all of which are going to be inserted facing outwards the fourth non painted piece will just need to line up with the remaining screw and dowel take four of the 20 cam locknuts and cert them in the circular holes on each wooden piece turn clockwise with a flathead screwdriver until tightened once you have the side of the Malm complete like Tom does you're going to take the other side and align it with the holes and gently press down and so all screws and dowels are inserted completely that the size of the Malm are finished you can flip it over so that it is in this position you're going to need screw four screws smaller holes and all four corners of piece seen here then take the four wooden dowels and insert them into the four large holes on the edges of the top of the Malm gently press or tap lightly until top is flush with the edges take the four thin nails and gently hammer one into each corner of what will be the back of the Malm moving onto the drawers you're going to need the face of the drawer inserting one screw into each corner of the back side using the small holes now you are going to take the two sides of the drawers and insert two wooden dowels into the larger holes on the ends and connect them to the screw holes on the front of the drawer insert the bottom of the drawer in the four locknuts into the matching holes on the outside of the sides of the drawers and tighten now take the final piece to the drawer and slide it into place matching screw holes up on either side and gently hammering plastic inserts into the four holes finally take the rails for each side of the drawer and insert three screws to complete the drawer repeat this process for the other drawer and slide the drawers into place