just because the motor is running doesn't mean that the dryer is tumbling let me show you the easier way to check to see if it's tumbling or not with the dryer connected to the wall outlet open the door on the dryer push the door switch in and hold it in that position set the timer on the beginning of the cycle and start the dryer if the motor is running but the drum is not tumbling you need to check the belt disconnected dryer from the wall Allah before proceeding you will need to use a party knife like these to open the top panel you will need to compress the holding clips like this with the poly knife compress the first clip then stick your finger between the top on front panel so it won't close on you then do the other side now open the top panel I leaned it against the wall like this check the belt to see if it's broken if he's broken it's going to be missing or it could be broken and still in top of the drum to remove the front panel you will need to loosen up these two screws and disconnect the wires from this wire hanger go ahead and remove it to all these screws and disconnect the wires from the wire hanger grab the front panel and pull it out a little bit lift it to unhook it from the bottom hooks and take it right out lean it against the dryer like this now make sure it's not going to fall down or it could break the door switch look inside of the dryer for the broken belt and remove it place the new belt around the drum like this now make sure that you put it the right way you should use long sleep to protect your arm when you put them under the drum now you need to get on the floor and stick your arms under the drum to connect the belt make sure that the grooves on the belt are facing up pull the idol pull it with your right hand and with your left hand place the belt around the motor pulley and under the Idol pulley like this turn the drum counterclockwise a couple times to make sure that the belt is nowhere to fall off and it stays on install the front panel make sure that you hook it on the bottom hooks first then set it in place unscrewing the two all these screws and hang the wires on the wire hanger make sure that none of the wires touch the spinning drama that will break lower the top panel and make sure that it snaps in place and let's go and try the dryer connect the dryer to the wall outlet open the door on the dryer and push the door switch and hold it set the timer on a cycle and turn the dryer on it's a riot on both nights like these and you were all set that was a way to check and replace the belt for the best place to buy replacement parts online visit repair clinic when you buy part from repair clinic you have 365 days from the day of purchase to return the part for a refund or for a replacement you can find links to repair clinic in my website