hey everyone its Mona here Kraft clutch today we're using our sphere molds again and we're going to use some resin and some candy sprinkles I have my spear molds and I told you I was going to experiment with some other things today we're experimenting with some candy and I have some candy sprinkles then I'm going to use different sizes and we're going to turn them into little smear pendants or charms so I have my easy cast mixed already and I'm going to pour just a little bit into each of the molds I'm going to add some of the sprinkles to the resins mix it in okay this way they're good and covered I'm going to scoop some out just put them right into the mold like that let it all sink so with any of the excess candy I'm just going to drop it right into one of these little paperweight molds or the half half spear molds that I've used for paperweights so this one is full and I'm going to just push it to the side a little bit and now I have the little one this one's going to be a challenge so I'll put more resin in my cup here and I'll add the little candy I've added more candy to the paperweight and these guys are drying again that little one not sure about it this one looks okay so far we're gonna let these cure a minimum of 12 hours and we'll come back and we will unmold them time for us to take these out of their molds and I'm just gonna start with the paperweight I think I could have put a color behind there also there you go that's kind of fun now if I had more candidate would have gone all the way to the bottom but and I'll sank and I just have a layer of resin here which is okay it's still fun all right I'm not sure how well I'm doing with this little mold definitely turned out better than I expected and then I have the bigger one and also turned out pretty good as well so if you'll notice there's a little bit of a lip here on the top I'm not sure you can see it right there and that's because I filled the mold to the top you could sand this down but I'm just going to take my dremel tool and I'm gonna just trim it all down then I put a very small tip on my Dremel tool and I'm going to just drill a hole into the top then I have my bead caps and my eye pins and I'm just going to glue them onto each of these I'm going to glue them on and I'm just using my ultimate glue you could use a super glue use whatever you feel you want to use that'll work alright I'm going to take two little bead caps and now I need to trim them down okay now I have the eye pin through the bead cap I dip my eye pin into the glue so it will have a little glue on there when I stick it in alright set it down if you have any excess glue you want to get rid of that hey make sure goes in all the way and then just let it dry thank you guys for watching me make these little candy charms and be sure to let me know what you think of them in the comments below why you're here remember to subscribe and check out some of my other videos I will see you next time remember life is too short not to shimmer so grab your glue gun and your glitter stay safe thanks guys