okay this is empathic yer compressor Capra's carseat to adjust the angle of the seed there is a button at the bottom of the seed red color you can pull this one right button so vertical put a pool facing and maximum angle you're facing okay the shoulder spreads must be below this line but must be higher than your baby's shoulder okay so the shoulder straps can be positioned through these holes okay so to loosen up these shoulder straps here is a way it says honest adjuster undercover sir under this cover sit cover here is the silver button it's a slip to lengthen so lift this out and then the same time you can put with the shoulder straps and to tighten the shoulder straps simply pull this one strap at the bottom to tighten okay this is the car seat protector they came in the box okay firstly this thing car seat protector top of your car seat okay so at the bottom of the this seed is this thing at the bottom so put a forward facing you place this one on back and put the wheel facing this thing need to be at the front okay I'm going to do we are facing in this video so put it on to the car met protector just hit it here okay once the card said is in the car next thing is to put my car sit down through the closet so you see these marks what's wrong under the seat get this hole okay and you on the other side just buckle this closet okay once this Paco we need to put on this safety belt clamp so before doing putting that on push this car sit down and at the same time and put the further shoulder side of the strip to lose all the flex on the left once the left side of the strip is tightened this clamp will go on the top shoulder side not on the left side just one layer one strip and right next to the little buckle and then secure it secure the clamp next is to put on this upper anchor so if your car has anchor point in store let's attach it to you anchor point on your car like that and just tighten this truck okay to tighten the upper anchor on the side let's pour this trip to let's just cut it up and installation is done and there will be a little bit of movement and according to the manual that is fine okay I missed at one point earlier and there's this button here on the side which can be locked to tie the upper Anchor Point strip and applies to both side okay so there is an additional accessory came in the box and there's a Sun canopy locking the Sun so basically goes on top on the side of the seat just button them up okay once fully button it looks something like this okay now the cop back headrests go back on and the casted protector and being secured a Titan