Today we're showing you how to properly assemble
and use ratchet straps. To begin, open the ratchet handle and align
the ratchet axle so the open slot is pointing up. This is easily done by ratcheting the axle
until the open slot is aligned. Now close the ratchet so the axle assembly
is easily accessible. The webbing should lead from underneath the
ratchet, through the axle, then back out the same way it entered. Next, place the hooks into position and pull
the loose end of the strap away from the ratchet to remove any slack. If you try to ratchet too much of the strap,
it will not only take longer, but could possibly ruin your strap or ratchet all together. To tighten the strap, raise and lower the
ratchet handle assembly. The strap will now begin to wrap around the
axle and tighten. Once tight, close the ratchet handle completely
to lock the strap in place. To release the strap, pull and hold the release
handle and open the ratchet completely. The strap will pop loose, and you can now
pull the ratchet to loosen the strap. Thank you for watching this demonstration
video on how to properly assemble and use ratchet straps