so everyone today i would like to introduce a new paper here plant the aries warrior this is the second paper airplane in the warrior collection so why not make it now to make the errors warrior you need printing paper i'm using use letter size but you can use a4 paper and if a4 paper does not work you can just trim it out to the us letter saturation first step i'll fold the paper in half and then unfold the paper now let's start from the top edge before to the bottom edge and i unfold the paper again and then the third step let's start from the top here fold it to the crease we just made okay and next i will fold the paper in half this way okay on the following step i will estimate about half an inch along this edge from this corner around this edge and just make a mark here and next i will start from this mark i'll fall straight to the corner here and then i turn the paper over i'll move the paper this way and then i repeat the same step as i did before all i need to do now is just match this edge to the edge here and then i start from this edge and fold it to this edge as you can see here i fold it more than this edge a little bit and now i can turn the paper over and i repeat the same fold you can move the paper this way to first easier and on the following step i unfold the paper and then i flip the paper over and now i'll fold the paper in half this way next step i will create the wings let's start from this edge i'll force straight to the bottom edge here i need to press as hard because the paper now is really hard to fall and i repeat the same step for the other side so turn the paper over and just pull it down okay next step i start from this edge and fold it to this edge same thing here for this side let's start from the edge here pull it to the edge on the top okay and then i will fold this edge here straight to this edge and i repeat the same fold for the opposite side let's start from the top here first okay and then i repeat the same s4 here this side yes now i just need to unfold the wounds you can see the wheels here i just unfold and i've turned the paper over to show you what they have this is the top stabilizer just pull it up this is the bottom after you finish the stabilizer you need one more step to do the paper airplane is almost finished however this stabilizers now is very high and that means it's created a lot of cracks on the back it causes the blend flame up and crushed out quickly to solve the problem we need to flatten down these stabilizers i will show you how to do it right now i'll pull the stabilizers out a bit like this to decrease the effect on the back and i'll repeat the same thing for the opposite side without warm and now you can take a look at the stabilizer this is almost flat for both sides and this makes the lens look much much better too and um okay so check it out and able to fly very well for you like the video share it with your friends and subscribe my channel thank you for watching bye you