I'm not one to mix them more so for me pointing a LED roof above it this mix is being made with three parts Sun and one part cement by volume as well as a nun full of being forcing fiber and then all this is going to mix together using SBR instead of water that will make the mix waterproof and also flexible I have already added three tins of Sun to the mixing bucket and I am now adding this immense the Firebird was quite difficult to find but I did manage to find someone eBay apparently there is enough fiber in that container to reinforce one cubic meter of concrete my money and I'm full to the mix and I am assuming that it is well rock and pop now I am using a mix of puddle and the evolution mixer to mix the mix until it is mixed thoroughly obviously this is a lot easier if you have a cement mixer but for those without one the mixer panel does work although it is I work it's important to mix them water thoroughly and so this is going to take about 10 to 15 minutes to mix it up properly never mix more mortar than you can use in the sand there once you admit the sound of the cement if you leave it overnight it will become unusable due to the moisture content in the sand once the mortar is mixed properly I am transferring enough mortar that I can use in about 20 to 25 minutes into a smaller bucket and the more to assume sets once you mix it with the SPR I'm now slowly adding the SBR to the mix and they have now mixing this using a gauging foul always at the svr in small amounts as you can always have more but you cannot take it out once you get to the correct consistency you have about 20 minutes to half an hour working time before the terms are difficult to work with it's best to clean all tools as soon as possible using clean water under statement rule you can see that now about consistent mix in the book it is not going to be used on the bucolic which will be covered in a later video applies to thank you for watching this video and if you have probably a useful please subscribe if you haven't done already you