okay guys this is a quick demonstration on how I made my my roller spinner first of all I got an old roller that I was no longer using I locked it in my voice like this I used a monkey wrench for the top and just slid it in between the the metal piece and the plastic piece and I gave it a sharp smack of a hammer to free up the roller itself I then went and purchased a piece of eight millimeter or sorry six millimeter threaded bar and a selection of not simple sorry vague about nuts and washers and this is the finished product as you can see with the paint that's already there this is an old roller that I salvaged I had to drill out the end piece here to take the six mil bar and the hardest part of doing this is actually threading the note all the way down you have to try to play with just the tip of your finger to get it all the way down here and the reason I have two nuts there and two nuts there is that there they lock against each other so that they when it's been spawn it doesn't loosen so that's the finished product and then I cut the bar I cut the barrel to the correct length and that's the finished product and here's the finished product let's say product you're gonna be making this up yourself your own Dowager Chad go ahead give it a test run now just to see how we get on and here we have a selection of the rollers that I had soaking Android and and here we have a view from the top you notice that the bucket is empty not bad at all excellent I'm very impressed with that and this cost me three euro so if you have that spare and old roller that you want to adapt it's gonna cost three euro for a paint roller you