and they will show you how to connect bits using Jam ring as well has wire to create loops for the beats so as I have variety of bits I will need to make use of copper wire to make loops at both end of the beat so this is us as you can see I'm pulling a pool of Walia I'm using 0.8 mm wire so are less inserted into the pit and leave about 0.6 centimeter at both end of the bead and cut off excess wire using your flat nose plier sorry your cutter okay place your feet at the center of the wire and make a 90 degree Bend using using a flat nose plier and I'm going to continue making a loot now with a round nose plier hole your bid and your copper wire family place the round nose plier at the tip of the copper wire and make sure that your palm is facing up and you need to estimate the size of your loop so in the event you need a smaller note look you will need to put it you will need to place the player with the smaller diameter but if you are making a bigger loop you will need to place it towards the back which has bigger diameter so as I have about 0.5 copper wire left here I will need to place my copper and sorry a round nose plier somewhere here so now I have started turning my wrist inward to make a loop can pull out adjust the loop so I have a very nicely done loop here in the event you are not happy with it you can reopen the loop and close it back again to make sure that the loop is placed at the centre so let's turn it to the other side and repeat the process for the second loop okay I'm done with the loop now let's see how to connect this bead to the chain of necklace that I had prepared earlier so now to connect a bit with the bit from the other side I will use a jump ring to help me so this is a jam ring you will need to open this jam ring from the opening here hold the site of the jungling with two pliers you can use two flat nose pliers if you have them if not you will use you can use one flat nose and one round nose plier open it as you can see my movement just now I was holding I was turning my plier upward and turning the other pliers down with to open it so this will have to maintain the shape after jump ring so now I insert the jamriang into the bead into and now I'm ready to close it and again home your flat nose pliers add both and both side of the jam ring and push them to the center to close it okay so now I have my bit connector to the chain now I'm going to connect the glass to the end of the necklace through a jump ring this time I'm using a smaller jump ring hey I'm done with one side of the class now let's repeat the process for the other side and I'm done with the whole entire network