so this is bleeding the boiler I'm sorry not boiler furnace the oil heating oil ran dry we had ever refilled and used to be but so what happens is now as we need to bleed it no big deal so what happens is there's this little valve down here kind of hard to see and then that's just loosened a little wrench you think this one was 3/8 and then what happens is it will bleed a little wet there it's not boil then push the air out so the reset button on top old priming so I'll go ahead and hit that and then you start to see where well come out of it and so linear in the line so they want that to be at state dreamless now I'm starting to get better at the system and want there to be almost solid I took it a lot better there [Applause] all right I think that one would qualify for it SoDo you don't looks like we got plenty of oil on the ground to which unfortunate but so we'll do now is we're gonna go ahead and restart the the process and without having any oil slip in we're going to go ahead and tighten up the bolt so I can't do that with the 292 hands for that but anyway I'm sure I could find a pivot point for this that's easy to see maybe easier to see not the easiest so I'm gonna go ahead and put my wrench up here on this thing before I have it I'm gonna restart the process now I'm tighten keep tightening the tough spot to get into looks like it's furnaces kicked on too it's almost there it's not quite tight enough so I need you to do a couple more times so I get my wrench ready reset well it's in a lockout so we needs to he's a few seconds to do everything so it's a good thing I have a newspaper down here and it's a paper towels because you can get messy so let's get ready again okay that should be it they drop the tool so I'm just gonna go ahead and make sure it's more right there all right I can reuse in this oil in your stuff all right cool