I installed the saw blade in the jigsaw table here I don't have the guide I used to keep the blade vertical because I need the space behind the blade to cut this board this word and the word I used to make the XO table are both the same thing I will cut two strips of it now I have the guide installed in my jigsaw table I am surprised how straight I made these cuts if they were not that straight I should send them until they were straight I will put Gwang a strip to each side of the jigsaw tabletop I have just the end of the strip's to the edge of the table top and I put this marquetry on them this sheet is four millimeters thick and I will have just there the edge of the sheet to the end of the strip's I apply some glue on the strip I put the sheet on the strip and I screw it I put some glue on the other strip I put the strip under the sheet I Drive just the tip of the first screw and now while I pull the sheet towards myself I push the plywood strip against the jigsaw tabletop and I Drive the screw and I Drive the other two screws and because the strips are too short now I have to turn the sled and I will use it that way it doesn't slide very well so I will apply some wax on the sides of the jigsaw table yes I should be careful about where I put the things I use I also put some wax on the plywood strips and on the surface under the sled - and now it has lights quite well so I will install the jigsaw blade and I will cut the groove I need in this a slit now I mark the width of this lead in that strip that strip will be the fence of this lid even when I cut freehand the cuts are nice they only need some sanding when I put the fence on the sheet I want the groove to go at least 5 millimeters under the fence I put the strip on the groove and at 90 degrees with it very carefully I turn everything I try to make sure I don't move the strip on the sheet and I Drive one screw until the head is flush with the sheets or face I turn it again and with the help of the groove the way you can see in the video I move the fence until it is at a perfect 90 degrees angle with the groove and now very carefully I turn it and I Drive one screw in the other side of the strip and if everything is still in the right position I finish it driving another two screws I use like the sled on the tabletop and I cut the vertical groove in the fence and now it should be ready to make a square and precise cuts I just have to adjust the cutting line to one side of the groove or to the other side and I can cut not worth in the next video I will talk about some things that we need to take into account when we make and when we use this jigsaw table if this is the first time you watch one of my videos you can find all my woodworking videos in my channel including how I made the jigsaw table and the guide to keep the blade vertical and if you like my videos thanks for subscribing to my channel thanks for watching you