another guide brought to you by CJ solutions that's www.infinitenourishment.com tents at your own risk CJ solutions dot n full max no representations warranties or conditions of any kind express or implied your performing these steps at your own risk right folks what we're going to do for this first step is remove the sheath from the coaxial wire we do this by running the knife carefully around the wire making sure to only cut through the top layer now you can bend the cable slightly to just check and make sure that it cuts all the way around once you're happy with the codes that are way around you should then run the knife along the cable from the cut to the end now you should just be able to peel the sheath off take the copper braid and twist it together like so remove some of the foil but don't remove all of it we now need to remove the inner sheet to expose the center core run the knife around the inner sheet like so this should then just put off and there you have it folks a stripped coaxial cable here we have a aerial coaxial socket if I just turn it over you can see the circuitry on the back you can see that there are three screws and two of these screws are for the grounding plane you see they're attached to a little clip and the third screw is for the center pin okay now we're going to do is undo those screws you remove the ground clip we now need to put the cable in place attach the center pin to the center pin screw put it just underneath the center pin screw tighten that screw and so that it holds the center pin in place we then need to put the ground clip in place and do up the two screws for that and there you have it one wired in coaxial cable and to a wall socket half-dazed be sure to follow us in all the usual places for updates and more guides thanks for watching folks and keep smilin