okay so now we got to build the final cupboard which is that corner cupboard which is probably the most difficult one of all because it's 90 degrees with a cantilever door so here we go so there's our first corner now we have to make the second part connects on the end to give us a nine degrees so now we got our second part of the cupboard so we'll go do now join these two arts together and we end up with annoying degree covered we just lock it all together with our camera now put the cover together there to insert the leg mounts into the holes as we've done on the previous covers on the back of your leg man there's a spigot which presses into the pre-drilled hole on the bottom of the cupboard on the inside of the leg mount there's a pin in the center that's molded into the plastic after you've pressed the leg mount into the pre-drilled hole your hammer in the pin so that in in turn spreads the back of the spigot and locks it into the hole now to avoid damaging the outer edge of our leg map we'll be hammering in our center pin I like to use a bit of a punch so I've cut myself a piece of scrap timber and it fits nicely in the center of there and I'm going to use that to avoid any damage to the outside of my leg now okay so we press our unit into the hole and then we drive the center down with our punch there it is solid as a rock so we do that with all our leg mounts before we press in the legs so just like before I'm going to set my legs to the same height so she doesn't wobble when I tip it up on its legs this way to go