this video I'm going to show you how to make a Wing Chun dummy for under $40 in this video you're going to need three sections of one and a half inch conduit a toilet flange that can go into a four inch diameter pipe five and a half feet of 4-inch diameter PVC pipe 15 inches of half-inch PVC pipe a drill a 1 and 3/4 inch hole saw and a 7/8 of an inch one fourths of an inch drill bit and a lot of 1/4 inch rope or tubing eight and a half inches from the top rail a hole with the 1/4 inch drill bit and then with the hole saw then three inches to the left and a little bit down reel another hole and in the center of the other two holes and 20 inches from the top drill another hole with the hole saw you might have noticed how these holes are not perfectly round this is actually only one in one fourths inch drill bit so I had to go in with a file and file it all which is not very fun then cut three ten inch pieces of the conduit then drill a hole with your 7/8 inch drill bit then cut another three sections of ten inch PVC pipe button but this time they have to have this edge on them stick one of the pieces in after you do that put another piece in an angle in mark where it would go through it when you're done with that use a hole saw and drill through the pipe you're going to need a base but my base as you can see is railroad tracks you could just bolt it to a board then assemble it half-inch PVC pipe into three five inch sections and put them through the holes then glue and wrap around the tubing or rope the top section in the middle section of the dummy then you're done thanks for watching